The smallest thing here that does the job — 20 sheets
A weighted single-clamp holder, 4.3 by 2.1 in, that stands one document upright beside the keyboard, publishes what it will take — up to 20 sheets — and is the cheapest holder here.
KPASXZA single-clamp weighted paper holder
Best for: A desk with no room for a stand, where one page at a time needs to stand up next to the keyboard.
This is the least ambitious holder in this hub and the clearest about it. A white 4.3 by 2.1 in body, a sprung clamp on top, a stated capacity of up to 20 sheets, and no angle adjustment of any kind — it stands one document up beside the keyboard and that is the whole proposition. At about $8 it is also the cheapest holder here.
The two things that decide whether a holder this small works are tipping and sliding, and KPASXZA names both. Weight is added inside the body “to prevent the holder from tipping over”, and a non-slip pad underneath keeps it in place. Loading is one-handed: press the front notch, drop the paper in, let go. Neither the weight nor the material is published, which is where the specification stops.
What sits in place of the rest of a specification is worth knowing before ordering: the product description is a seller note about manual measurement tolerance, monitor color variation and customer satisfaction rather than anything about the holder. Against that, the capacity figure is published — six holders in this hub give no sheet count at all — though at 20 sheets it is a holder for the page in hand, not for a report; the 3M takes 150.
Read on the day this page was built: $8 at the American Amazon shop.
Read from Keepa on the day this page was last revised; stock and price both move without notice.
Best for: A desk with no room for a stand, where one page at a time needs to stand up next to the keyboard.
Prices quoted in this text were read on 2026-10-13. The live price is at the top of the page.
KPASXZA states that weight is added inside the holder "to prevent the holder from tipping over", and that a non-slip pad on the bottom stops it sliding. Those are the two mechanisms a holder this small has available to it, and the listing names both — it does not publish the weight itself.
The listing describes it precisely: "press down on the front notch, put the paper down and take your finger away, the clamp will secure the paper tight". It is a sprung clamp rather than a sliding clip, which is the difference between one-handed and two-handed loading.
The title says A4. The clamp holds the sheet at its foot only, so nothing supports the top of the page; the seven-position stands in this hub hold the whole sheet against a back.
A weighted reference display holding ten pivoting pockets — up to 20 letter-size sheets visible at once — on a 12-inch base with compartments for pens and small supplies.
Best for: A workstation that reads the same twenty pages every week — procedures, price lists, schedules — rather than one document at a time.
A small upright steel mesh letter rack with three compartments of different heights, for sorting mail on a desk corner — priced on Amazon.com at more than three times its German price.
Best for: A desk corner where incoming mail and a few loose papers need sorting, not a document to type from.
A folding holder with a grooved ledge and a height-adjustable sliding clip, stated to hold up to 150 sheets in either orientation — the highest sheet count published in this hub.
Best for: Working through a thick document rather than a single page, in whichever orientation it was printed.
A full-motion dual mount that publishes both its reach and its rise — with the Acer, the only one here that does — tested to 20,000 cycles, at about $50.
Best for: Two screens up to 32 in on a deep desk, where published reach and rise matter more than a thick-desk clamp.
A mechanical-spring articulating mount with open-top VESA plates for slide-on fitting — and the only listing on this shelf to warn that the arms project beyond the back of the desk.
Best for: A desk standing clear of the wall, where a mechanical spring is preferred to a gas cylinder.
A steel desk-clamp mount for two 13 to 32 in screens at up to 8 kg (17.6 lb) each, with a 5-year guarantee — about €21 in Germany but about $58 on Amazon.com.
Best for: Two light-to-medium screens on a standard desk, for a buyer who values a long guarantee — ideally bought at the European price.